• Fast changing from drilling to driving
• Designed for use with a hammer drill and Tapcon drill bits
• Simplifies the process of changing from drill to drive
• Eliminates the need for two drills
• Can install all sizes of hex and Phillips head fasteners

Installation Instructions:

Drill
Using a hammer drill, drill a hole 1/4" deeper than anchor embedment.

Slide (optional)
Slide Condrive installation tool over drill bit and drill adapter and position Tapcon concrete anchor onto tool.

Drive
Drive Tapcon anchor into pre-drilled hole until anchor is fully seated.

Tapcon anchors require a minimum embedment of 1" and a maximum embedment of 1-3/4".