• Fast installation: drill a hole and drive an anchor
• Replaces small-diameter expansion anchors, plugs, and screws in light- to medium- duty applications
• No inserts are required
• Reversible and removable
• Can be installed close to the edge of concrete
• Thread design results in increased pullout values and lower installation torques
• Climaseal® coating provides extra corrosion resistance
• Recommended for use in ACQ pressure-treated lumber

Click Here for Available Sizes

Installation Instructions:

Drill
Using a hammer drill, drill a hole 1/4" deeper than anchor embedment.

Slide (optional)
Slide Condrive installation tool over drill bit and drill adapter and position Tapcon concrete anchor onto tool.

Drive
Drive Tapcon anchor into pre-drilled hole until anchor is fully seated.

Tapcon anchors require a minimum embedment of 1" and a maximum embedment of 1-3/4".